Gelbo Flex tester with Particle counter for non-woven, textile testing

New data sheet for Gelbo Flex tester with Particle Counter 

Email: marketing@idminstruments.com.au


Gelbo Flex tester with particle counter

Non-woven testing instrument

Gelbo Flex Tester data sheet

Gelbo flex particle counter

Comments

Post a Comment

Popular posts from this blog

Advancements in Foam Porosity Measurement

Image
The first version of IDM Instruments’ Foam Porosity Tester F0016 was designed and released in the 1980s, in accordance with global industry standards, and was used to determine the ease with which air passed through a cellular structure, namely foam, by comparing the relationship between pressure and flow when subjected to different foam samples. It used vacuum chambers with manometers and was controllable via a manual dial to fine tune flow. This version was purely analogue and required fine use of the dial and flow tubes to be able to give accurate test results. Due to the purely analog design, it was difficult to achieve accurate yet repeatable test results. After more design and upgrades, the second version Foam Porosity Tester F0023 was released in late 2001. Once again improving the accuracy of foam porosity testing. This model boasted variable flow ranges, allowing for more ranges of conditions of testing foam porosities. A huge feature of this model was...
Read more

IT9101 - Inclinometer

Image
The IT9101 is a rugged and simple device which provides a voltage divider feedback signal for incline position. The heart of the IT9101 is a magnetically-damped pendulum coupled to a conductive plastic precision potentiometer. A highly linear relationship between inclination and the output signal is maintained over the full range of the IT9101. The inclinometer has an operating temperature of -34 to 90 degrees Celsius. For more information, please visit the IDM website at: www.idminstruments.com.au
Read more

B0008 - Bedding Impact Tester

Image
The B0008 - Bedding Impact Tester has been designed and manufactured to perform various tests and evaluations of Innerspring , Boxspring and Foam mattresses , as well as Chairs , Cushions and other similar products. The machine consists of a 79.5 ± 1kg platen, which drops down and impacts the test specimen from various heights as selected by the operator. This allows comparison of results obtained by impacts from different heights. The machine can be used to impact any locations on the specimen, including middle areas, corners and edges to compare performance of both inner and outer components. The machine operates by testing each product at the same position, once a location is set for comparison. The Bedding Impact Tester meets to the following standards: ASTM F1566 American Innerspring Manufacturers (AIMA) For more information, please visit the IDM website at: www.idminstruments.com.au
Read more